4
e.
CAUTION: Ensure the engine is completely cool before removing the coolant hose, or hot coolant will escape
from the cooling system and cause injury or damage. Be sure to capture any lost coolant in a clean container.
Remove the corresponding coolant line that is attached to the PCV line and replace with the provided 5/16” hose
(5-2014). Secure with the provided hose clamps (4093-5). There are two ports for the coolant as shown in the middle
photo. Use caution, small amounts of coolant will spill out. Be sure to capture any lost coolant in a clean container. Also
use a rag to cover any areas where coolant may leak. Be sure to clean up any spilled coolant. After the new hose
(5-2014) is installed and secured, replace any coolant recovered during the hose removal by replenishing the recovery
tank.
f. Remove the battery by removing the battery tie
down and disconnecting the positive terminal.
g. Loosen the hose clamp securing the inlet tube to
the throttle body. Also, remove the wiring harness
from the inlet tube.
h. Unplug the wire harness connection from the MAF
sensor.
i. Remove the green clip securing the wire harness to
the airbox panel.
