12
t. Wheel well liner and bottom plastic tray: Install the
wheel well liner, bottom plastic tray and any hardware
that was removed during steps 2p-2q.
NOTE: Failure to install the fender liner will result
in diminished performance and increase the po-
tential for engine damage due to water ingestion in
rainy conditions.
u. Install the driver side wheel using the factory torque
specification (see owner’s manual).
Factory airbox system installed
AEM
®
intake system installed
4. Reassemble Vehicle
a. Position the inlet pipes for the best fitment. Be sure that the pipes or any other components do not contact any part
of the vehicle. Tighten the rubber mount, all bolts, and hose clamps.
b. Check for proper hood clearance. Re-adjust pipes if necessary and re-tighten them.
c. Inspect the engine bay for any loose tools and check that all fasteners that were moved or removed are properly
tightened.
d. Reconnect negative battery terminals and start engine. Let the vehicle idle for 3 minutes. Perform a final inspection
before driving the vehicle.
5. CARB Sticker Placement
a. The C.A.R.B. exemption sticker, (attached), must be visible under the hood so that an emissions inspector can see
it when the vehicle is required to be tested for emissions. California requires testing every two years, other states
may
vary.
