ENGLISH #
WS 700-100, WS 700-115, WS 700-125, WSE 700-115
Advices for
operation
When grinding do not apply pressure on the tool but use it with gentle reciprocating
movements.
Rough grinding
For best results when roughing-down keep the disk at an angle of at least 30° to the
working surface.
Overloading the machine when grinding will damage the angle grinder and results
in faster wearing out of the disks. Grinding performance will suffer.
Never use a cutting disc for grinding. Do not subject cutting discs to side pressure.
Separating
Do not tilt the angle grinder when separating. The cutting disk must have a clean
edge.
When separating stone the guide shoe must be used!
Surface grinding
When surface grinding use a plastic backing pad with an abrasive disk.
For removing rust or old coats of paint it is recommended to use a steel brush
(saucepan brush).
Optimum speed
of rotation
(WSE 700-115)
The optimum speed of rotation also depends on the hardness of the material to be
worked as well as the quality of the used working tool:
Service
Keep the machine and the ventilation slots clean.
Use only AEG accessories and spare parts. Should components need to be re-
placed which have not been described, please contact one of our AEG service
agents (see our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please state the ten-digit
No. as well as the machine type printed on the label and order the drawing at your
local service agents or directly at:
Atlas Copco Electric Tools GmbH, Postfach 320, D-71361 Winnenden.
Accessories
The range of accessories and their part numbers are shown in our catalogue.
Usage
Electronics
Sanding of plastics with backing pad and abrasive paper
A-C
Sanding wood and removal of paint with backing pad and abrasive
paper
B-D
Sanding of metal with backing pad and abrasive paper
C-F
Removal of rust from metal with steel-wire brushes
D-F
Grinding of steel, Cutting steel and stone
G
Polishing with backing pad and lambswool bonnet
A-B
