ENGLISH #
WS 700-100, WS 700-115, WS 700-125, WSE 700-115
Introduction
You demand the best and buy quality - quality provided by Atlas Copco. We have
built for you a reliable and lasting tool. Working effectively and without endangering
your health is only possible if this instruction for use is read carefully before first us-
ing the tool. We want to satisfy our customers and would like you to buy again AEG
Electric Power Tools from Atlas Copco.
Technical Data
Safety advice
■
Please note safety instructions on red sheet 4 000 333 024!
■
Do not pierce the motor housing as this could damage the double insulation (use
adhesives).
■
Always pull the plug from the mains before making any settings or carrying out main-
tenance.
■
Only plug-in when machine is switched off.
■
Keep mains lead clear from working range of the machine. Always lead the cable
away behind you.
■
Before use check machine, cable, and plug for any damages or material fatigue. Re-
pairs should only be carried out by authorised service agents.
■
After switching off, the machine will not be idle immediately. (After-running of the
work spindle.) Allow the machine to come to a stop before putting down.
■
Never reach into the danger area of the machine when it is running.
■
Always wear safety goggles and ear protectors when working with this machine. It
is further recommended to wear safety gloves, apron, as well as sturdy non-slipping
shoes.
■
Always use the additional handle.
■
Always use the protecting cap when roughing-down and separating.
■
Only use tools whose permitted speed is at least as high as the highest no-load
speed of the machine.
■
Pay attention to the dimensions of the grinding disc. The mounting hole diameter
must fit the mounting flange without play. Do not use reducer pieces or adapters.
■
Check grinding tools before use. The grinding tool must be properly mounted and
turn freely. Perform a test run for at least 30 seconds without load. Do not use dam-
aged, out of round or vibrating grinding tools.
■
Immediately switch off the machine in case of considerable vibrations or if other mal-
functions occur. Check the machine in order to find out the cause.
■
Always use and store the grinding disks according to the manufacturer’s instruc-
tions.
■
When grinding metal, flying sparks are produced. Take care that no persons are en-
dangered. Because of the danger of fire, no combustible materials should be locat-
ed in the vicinity (spark flight zone). Do not use dust extraction.
■
Due care should be taken that no sparks or sanding dust flying from the workpiece
come into contact with you.
Type
WS 700-100 WS 700-115 WS 700-125 WSE 700-115
Nominal power (W)
710
710
710
710
Min. no-load speed (min
-1
)
2700
Max. no-load speed (min
-1
)
11000
10000
10000
10000
Grinding disk diameter (mm)
100
115
125
115
Thread of work spindle
M10
M14
M14
M14
Weight (kg)
1.6
1.6
1.6
1.6
Speed control
–
–
–
•
No-load speed limiter
–
–
–
•
Smooth start
–
–
–
•
