13
ENGLISH
Problem
Possible cause
Solution
The wine is too
warm.
Temperature is not
properly adjusted.
Please look in the “Use”
section.
Door was open for an
extended period.
Open the door only as long as
necessary.
The appliance is near a
heat source.
Please look in the “Installation”
section.
Interior lighting
does not work.
Light bulb is defective.
Please look in the
“Maintenance” section.
Unusual noises.
Appliance is not level.
Readjust the feet.
The appliance is touching
the wall or other objects.
Move the appliance slightly.
A component, e.g. a pipe,
on rear of the appliance is
touching another part of
the appliance or the wall.
If necessary, carefully bend
the component out of the way.
Heavy build up of
the frost, possibly
also on the door
seal.
Door seal is not air tight
(possibly after changing
over the hinges).
Carefully warm the leaking
sections of the door seal with
a hair dryer (not hotter than
approx. 50 °C). At the same
time shape the warmed door
seal by hand such that it sits
correctly.
The compressor
does not start
immediately
after changing
the temperature
setting.
This is normal, no error
has occurred.
The compressor starts after a
period of time.
Water on the
floor.
Water drain hole is
blocked.
See the “Cleaning” section.
WARNING!
Before troubleshooting, discon-
nect the power supply. Only a
qualified electrician of competent
person must do the troubleshoot-
ing that is not in this manual.
TROUBLESHOOTING
IMPORTANT!
There are some sounds during
normal use (compressor, refriger-
ant circulation).
RWE72101DB_Wine_cellar_AEG_EN_EL.indd 13
02/11/16 8:48 PM
