12 www.aeg.com
15.
Put the door on the lower hinge.
Keep the door cling the cabinet and
put the upper hinge into the hinge
hole. The right and left side of the
door must aline with the sides of the
cabinet. And then securely fix the
upper hinge
16.
Place the top cover on the top of the
refrigerator and push it to back side
until it is hooked by the fixed blocks.
17.
Fixed the top cover by the tow
screws.
LEVELLING
The appliance should be level in order
to eliminate vibration. There are 4 height
adjustable feet at bottom of the
appliance, 2 feet in the front and 2 feet in
the back. To make the appliance level, it
should be upright and all feet should be
firmly contacted with the floor.
Warning:
Reposition, level the appliance,
wait for at least four hours and then
connect it to the power socket. In case
you do not want to carry out the above
mentioned operations, contact the near-
est After Sales Service Force.The After
Sales Service specialist will carry out the
reversibility of the doors at your cost.
Warning:
After having reversed the
opening direction of the door check that
all the screws are properly tightened and
that the magnetic seal adheres to the
cabinet If the ambient temperature is cold
(i.e. in Winter), the gasket may not fit per
-
fectly to the cabinet. In that case, wait for
the natural fitting of the gasket. Lay down
the appliance back side down.
ELECTRICAL CONNECTION
• Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic
power supply.
• The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with cur-
rent regulations, consulting a qualified
electrician.
• The manufacturer declines all responsi-
bility if the above safety precautions are
not observed.
• This appliance complies with the E.E.C.
Directives.
RWE72101DB_Wine_cellar_AEG_EN_EL.indd 12
02/11/16 8:48 PM
