CAUTION!
Be careful when you remove
the shelf supports. The
catalytic panels are not
attached to the oven walls
and can fall out when you
remove the shelf supports.
1. Pull the front of the shelf support
away from the side wall. Hold the
rear shelf runners and catalytic panel
in place with the other hand.
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
2
1
Install the removed accessories in the
opposite sequence.
The retaining pins on the
telescopic runners must
point to the front.
11.4 How to use: catalytic
cleaning
The cavity is coated with a catalytic
enamel. It absorbs fat.
Before you turn on the cleaning:
• remove all the accessories and
removable shelf supports.
• clean the oven floor with warm water
and mild detergent.
• clean the inner door glass with warm
water and soft cloth.
1. Turn on the oven.
2. Press again and again until the
display shows: "Cata". The cleaning
takes 1 hour.
You cannot change the duration of the
cleaning. You can delay the start of the
cleaning with the function: END.
The signal sounds at the end of cleaning.
The oven turns off.
3. Press any sensor field to stop the
signal.
4. When the oven cools down, clean the
cavity with a wet soft cloth.
Spots or discolouration of the catalytic
coating have no effect on Catalytic
cleaning.
11.5 Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
The door is heavy.
1. Open the door fully.
2. Fully lift up the clamping levers (A)
on the two door hinges.
A
A
3. Close the door until it is at an angle
of approximately 45°.
45°
ENGLISH
27
