1
Spanner
To remove the transit bolts.
2
Plastic caps
To close the holes on the rear side of
the cabinet after the removal of the
transit bolts.
3
Anti-flood inlet hose
To connect the appliance to the
water tap and to prevent possible
leakage.
4
Plastic hose guide
To connect the drain hose on the
edge of a sink.
5.3
Positioning and levelling
1.
Install the appliance on a flat hard
floor.
Make sure that carpets do
not stop the air circulation
below the appliance.
Make sure that the
appliance does not touch
the wall or other units.
2.
Loosen or tighten the feet to adjust
the level.
WARNING!
Do not put cardboard, wood
or equivalent materials
below the appliance feet to
adjust the level.
x4
The appliance must be level and stable.
A correct adjustment of the
appliance level prevents the
vibration, noise and the
movement of the appliance
when in operation.
When the machine is
installed on a plinth or if a
washer dryer is stacked on
the washing machine, use
the accessories described in
chapter 'Accessories'. Read
carefully the instructions
supplied with the appliance
and with the accessory.
5.4
The inlet hose
1.
Connect the water inlet hose to the
back of the appliance.
2.
Position it toward left or right
depending on the position of the
water tap.
20º
20º
45º
45º
Make sure that the inlet hose
is not in vertical position.
3.
If necessary, loose the ring nut to set
it in the correct position.
www.aeg.com
10
