Defective light bulb.
Replace light bulb (see next
section).
Displayed programme time
changes erratically or stays un
-
changed for a long time.
Programme time is corrected
automatically depending on
type and volume of laundry
and level of dampness.
Automatic process; this is not a
machine fault.
Programme inactive, empty
water tank icon is on.
Condensate tank is full.
Empty condensate tank, then
start programme with START
PAUSE button.
Drying cycle ends shortly after
programme starts. END display
illuminated.
Not enough washing loaded or
washing loaded is too dry for
selected programme.
Select time programme or
higher drying level (e.g. INTEN
-
SIVE DRY instead of STORAGE
DRY).
Drying cycle lasts an unusually
long time. Note: After around 5
hours the drying cycle ends
automatically (see „Drying cy
-
cle complete ”).
Lint filter clogged.
Clean lint filter.
Fluff filter clogged.
Clean fluff filter.
Load volume too big.
Reduce load volume.
Laundry insufficiently spun.
Laundry must be adequately
spun.
Particularly high room
temperature. Temporary
switching off of the compres
-
sor to avoid overload.
Automatic process, there is no
fault with the appliance. If pos
-
sible, lower the room tempera
-
ture.
Changing the bulb for interior lighting
Only use a special bulb which is designed specially for dryers. The special bulb can
be obtained from the Customer Care Department, ET no. 112 552 000-5.
When the appliance is switched on, the interior lighting switches itself off after 4
minutes when the door is open.
WARNING!
Do not use standard bulbs! These develop too much heat and may damage the
machine!
WARNING!
Before replacing the bulb, disconnect the mains plug.
1. Unscrew cover above the bulb (this can be found directly behind the loading
aperture, at the top; refer to “Description of machine” section.)
What to do if ...
29
