Water-stop device
A
The inlet hose is provided with a water stop
device, which protects against damage
caused by water leaks in the hose which
could develop due to natural ageing of the
hose. This fault is shown by a red sector in
the window
«A»
. Should this occur, turn the
water tap off and refer to your Service Cen-
tre to replace the hose.
Water drainage
• The height of drain hose
do not have
to exceed 100 cm.
• The drain hose may be extended to a maximum of 4 metres. An additional drain hose
and joining piece is available from your local Service Centre.
• The drain hose must not be kinked and must be fastened to prevent it falls down.
The end of the drain hose can be positioned in three ways:
Directly into a drain pipe.
Attach the hook to drain hose and hang it in the drain pipe.
Make sure that the drain hose doesn't fall down.
The end of the drain hose must always be ventila-
ted, i.e. the inside diameter of the drain pipe must
be larger than the outside diameter of the drain
hose.
Hooked over the edge of a sink using the plastic
hose guide supplied with the machine.
In this case, make sure the end cannot come un-
hooked when the machine is emptying. This could
be done by tying it to the tap with a piece of
string or attaching it to the wall.
MAX 100cm
Installation
43