AEG L8WEC166C, User Manual

Page: 36 / 56

14. DAILY USE - WASHING & DRYING
WARNING!
Refer to Safety chapters.
This appliance is an
automatic washer dryer.
14.1 Complete wash&dry
programmes
Non-automatic wash&dry
programmes
In some washing programmes, you can
combine Wash and Dry mode for running
a complete wash&dry programme.
Proceed as follows:
1. After loading laundry and detergent,
press the On/Off button for some
seconds to activate the appliance.
2. Turn the programme dial to the
desired washing programme. The
display shows the default
temperature and spin. If necessary,
change them according to your
laundry. The display also shows the
maximum recommended load for
washing phase.
3. Set the desired options, if there are
available.
4. Touch the Mode button once to
activate also the drying function. The
Wash and Dry indicators come on.
The indicators and
appear on the display. The display
also shows the maximum
recommended load for a washing
and drying programme (e.g. 6 kg for
cottons).
5. Open the door and load the laundry
one item at a time. On the display the
weight of the laundry is updated by
steps of kg 0.5 and the programme
duration is updated accordingly.
6. Close the door.
7. Put the detergent and the additives in
the appropriate compartment.
When drying a large laundry
load, make sure that the
garments are not rolled up
and that are uniformly
distributed in the drum.
14.2 Washing and Drying -
Automatic levels
1. Tap on the Auto Drying button
repeatedly until the display shows the
required dryness level. The indicators
in the display illuminate accordingly:
a. Iron dry: for cotton
items;
b. Cupboard dry: for
cotton and synthetic items;
c. Extra dry: for cotton
items.
The time value on the display is the
duration of both cycles washing and
drying.
To have a good drying by
using less energy and in a
shorter time, the appliance
does not let you set a too
low spin speed for the items
to be washed and dried.
2. Touch button Start/Pause to start the
programme. The ProSense
estimation starts.
In the display the door locked
indicator goes on, the indicator of the
running phase starts flashing.
The display also shows the remaining
programme time.
14.3 Washing and Timed
Drying
1. Tap on the button Time Drying
repeatedly to set the desired time
value (see the "Timed drying" table
the "Programmes" chapter). The
drying level indicator goes off and the
indicator comes on.
Each time you tap on this button the time
value increases by 5 minutes. The
display shows the set new time value.
www.aeg.com 36