PowerSlide
This function allows you to adjust the
temperature by moving the cookware to
a different position on the induction
cooking area.
• The function divides the induction
cooking area into three areas with
different heat settings. The hob
detects the position of the cookware
and adjusts the heat setting
corresponding with the position.
• You can place the cookware in the
front, middle or rear position. If you
place the cookware in the front you
get the highest heat setting. To
decrease it, move the cookware to
middle or rear position.
• When you activate the function for the
first time you will get the following
default heat settings: 9 for the front
position, 6 for the middle position and
3 for the rear position.
• You can change the heat settings for
each position separately. The hob will
remember your heat settings next
time you activate the function.
• The heat setting display of the left
front control bar shows the heat
setting for this function. To change
the heat setting use the left front
control bar only. The left rear control
bar is deactivated while the function
operates.
Use only one pot with a
minimum bottom diameter of
160 mm when you operate
the function.
1. Place the correct cookware on the
left front side of the cooking area.
2. Press and hold to activate the
hob.
A signal sounds and indicators above
and appear.
3. Press to activate the function.
A signal sounds and an indicator above
the symbol appears.
4. Move the cookware back and forth
on the cooking area as needed.
The heat setting level on the control bar
adjusts automatically.
5. To change the default heat setting
levels, move the cookware to the
area you want to adjust first.
6. Press any of the available heat
setting levels on the left front control
bar.
The updated heat setting levels will be
remembered for the next time you use
the function.
7. Repeat the procedure for the
remaining cooking areas, if needed.
8. To deactivate the function, press .
You can also press 0 on the left front
control bar.
A signal sounds and the indicator above
the symbol disappears. The heat setting
level changes to 0.
You can set a timer while PowerSlide
operates. In this case the timer does not
deactivate the cooking zones when the
set time runs out. The timer affects all
three cooking areas activated by the
function at the same time.
6.7 Hob²Hood
It is an advanced automatic function
which connects the hob to a special
hood. Both the hob and the hood have
an infrared signal communicator. Speed
of the fan is defined automatically on
www.aeg.com
16
