Touch the control bar at the correct heat
setting or move your finger along the
control bar until you reach the correct
heat setting.
0
3
5
8
10
14 P
4.4
Using the cooking zones
Put the cookware on the cross / square
which is on the surface that you cook.
Cover the cross / square fully. Induction
cooking zones adapt to the dimension of
the bottom of the cookware
automatically. You can cook with the
large cookware on two cooking zones at
the same time.
4.5
Bridge function
This function connects two cooking
zones and they operate as one.
You can use this function for cookware
larger than 260 mm.
First set the heat setting for one of the
cooking zones.
To activate the function:
touch . To
set or change the heat setting touch one
of the control sensors.
To deactivate the function:
touch .
The cooking zones operate
independently.
When you use only one cooking zone of
the pair we recommend that you use the
rear cooking zone. Also when you use
large cookware we recommend that you
put it near to the rear cooking zone.
4.6
Automatic Heat Up
If you activate this function you can get a
necessary heat setting in a shorter time.
The function sets the highest heat setting
for some time and then decreases to the
correct heat setting.
To activate the function the
cooking zone must be cold.
To activate the function for a cooking
zone:
touch ( comes on).
Immediately touch the correct heat
setting. After 3 seconds comes on.
To deactivate the function:
change the
heat setting.
4.7
Power function
This function makes more power
available to the induction cooking zones.
The function can be activated for the
induction cooking zone only for a limited
period of time. After this time the
induction cooking zone automatically
sets back to the highest heat setting.
Refer to “Technical
information” chapter.
To activate the function for a cooking
zone:
touch . comes on.
To deactivate the function:
change the
heat setting.
4.8
Chef function
This function activates all cooking zones
and automatically activates for all of
them the Bridge function. The function
sets the same heat setting as the one
you set the last time.
For the first activation the heat setting of
the left pair of zones is set to
, the
middle pair is set to and the right pair
is set to .
To activate the function:
touch . The
indicator comes on. All cooking zones
operate for 9 minutes. If the cooking
zones stay empty, the symbol comes
on. After 9 minutes an acoustic signal
sounds and the empty cooking zones are
set to .
To resume this function:
touch to put
or move cookware on the deactivated
pair of cooking zones.
To deactivate this function:
www.aeg.com
28
EURO Appliances - euappliances.info
