AEG GS55AIW, User Manual

Page: 19 / 48

• The spray arms are clogged.
• The filters are clogged or not
positioned correctly.
• The selected level of the water
softener is not appropriate for the
hardness of your water supply.
12.3 Poor drying results
• Tableware has been left too much
time inside a closed appliance.
• The selected programme has no
drying phase.
• The selected programme has a drying
phase with low temperature.
• The dosage of rinse aid is not
enough. Set the rinse aid dispenser to
a higher level.
• There is no rinse aid in the rinse aid
dispenser.
• Plastic items may need to be towel
dried.
• Dishes have not been arranged
properly in the baskets.
• Arrange the tableware avoiding, if
possible, contact points. This will
allow water to reach all surfaces.
• Arrange kitchen utensils in a sloping
position.
• The interior of the appliance is wet
caused by the humidity in the air that
condenses on the inner sides of the
appliance. This is not a defect of the
appliance.
• Multi-tablets may give poor drying
results. Try a different brand of multi-
tablets. The use of rinse aid together
with multi-tablets can help to increase
drying performance.
• The cutlery is not dry. Cutlery has not
been arranged properly in the cutlery
basket.
12.4
Traces of rust on cutlery
• A lower grade of stainless steel of the
cutlery is less resistant to corrosion in
damp dishwasher environment. Use
high grade stainless steel or remove
the items from the appliance
immediately after the end of the
programme.
• There is too much salt in the water
used for washing. This could be
caused by the salt cap that is not
correctly closed or if the salt container
has been replenished recently, a
quantity of salt was spilled in the tub.
• Silver and stainless steel cutlery were
placed together. Avoid to put silver
and stainless steel items close
together.
12.5 Limescale deposits on the
tableware, on the tub and on
the inside of the door
• The is no salt in the salt container.
• The selected level of the water
softener is not appropriate for the
hardness of your water supply.
• The tap of the salt container has not
been properly closed.
• The quantity of detergent was not
enough.
• The detergent was not suitable.
12.6
Visible bluish film on
glasses and cutlery, on the tub
and on the inside of the door
• The dosage of rinse aid is too much.
Set the rinse aid dispenser to a lower
level.
12.7
Chipped tableware
• Place all items carefully in the baskets
and do not overload.
• Place delicate items in the upper
basket.
• Place glasses so they do not touch
each other and cannot move during
the washing.
• Move baskets in and out slowly.
• Make sure that items do not touch the
top of the tub when the upper basket
is pushed in.
• Fine antique china and crystal should
be hand-washed.
12.8 Excess of moisture on the
baskets and inside the
appliance
• There is no rinse aid in the rinse aid
dispenser.
ENGLISH 19