AEG GS55AIW, User Manual

Page: 18 / 48

Problem/alarm code Possible solution
The remaining time in the
display increases and skips
nearly to the end of pro-
gramme time. • This is not a defect. The appliance is working correctly.
The appliance door is diffi-
cult to close. • Parts of the tableware are protruding from the baskets
(e.g. pot or pan handles, ladles).
Rattling/knocking sounds
from inside the appliance. • The tableware is not properly arranged in the baskets,
items are touching each other.
• One or both spray arms are touching the tableware
while turning. Make sure that the spray arms can rotate
freely otherwise the cleaning results will be heavily affec-
ted.
The appliance trips the cir-
cuit-beaker. • The amperage is insufficient to supply simultaneously all
the appliances in use. Check the socket amperage and
the capacity of the meter or turn off one of the applian-
ces in use.
• Internal electrical fault of the appliance. Contact an Au-
thorised Service Centre.
The appliance does not fill
with water.
The display shows the alarm
code
.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not
too low. For this information, contact your local water
authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clogged.
• Make sure that the inlet hose has no kinks or bends.
The appliance does not
drain the water.
The display shows the alarm
code
.
• Make sure that the sink spigot is not clogged.
• Make sure that the filter in the outlet hose is not clog-
ged.
• Make sure that the drain hose has no kinks or bends.
The anti-flood device is on.
The display shows the alarm
code
.
• Close the water tap and contact an Authorised Service
Centre.
Once the controls have been done,
deactivate the appliance and wait 5
minutes before activating it again. If the
problem persists or the alarm code
continues to appear, contact an
Authorised Service Centre.
When you contact the
Service Centre always
remember to give the alarm
code (when available).
12.2
Poor washing results
• The baskets have been overloaded.
• Tableware has not been properly
arranged.
• The quantity of detergent was not
enough.
• The detergent was not suitable or old.
• The programme was not appropriate
for the degree of soil and the type of
load.
• The spray arms were blocked by the
tableware and could not rotate freely.
www.aeg.com 18