Measuring instructions
Take off the protective cap (1).
Make sure that both the measuring lens and ear
canal are clean.
Push the
On/Mem
button (3). The device is ready
as soon as the display starts to show (Fig.
1
) and
two beeps can be heard.
Please stand, sit or lie still.
Start measuring. Gently pull the ear back to
stretch the ear canal. To get a correct measuring
result you should direct the sensor (5) to the
eardrum (Fig.
2
).
- For children under the age of 2 years, gently
pull the outer ear back (Fig.
3
).
- For adults and children older than 2 years,
gently pull the ear up and then back (Fig.
4
).
Push the measuring button with your index finger.
When the measuring process is completed (after
about 1 second) the device will beep.
The measured temperature is indicated, the
symbol blinks for about 5 seconds and the
device beeps two times. The device is now ready
for a new measurement.
If the temperature is too high ‘
Hi
°C’ will be indi-
cated, if it is too low you will see ‘
Lo
°C’ on the
display.
After 1 minute or by holding the
On/Mem
button
pushed down, the device switches off automati-
cally. Only the
last
reading will be saved.
If you push the
On/Mem
button again after you
switched on the device or push it repeatedly, the
display will show the readings of the last measu-
rements (memory function for up to nine readings
(Fig.
5
)).
Conversion from Celsius (°C) to
Fahrenheit (°F)
Switch the device off. Concurrently push the
measuring button (7) and the
On/Mem
button.
The display will now show ‘°
F
’. You can now use
the device as herein described. To change the
display mode back just repeat this process.
Fever alarm
The device has a ‘Fever Alarm’function. If the
body temperature is above 37.5 °C (99.5 °F) you
will first hear one long beep and then three short
beeps.
25
GB
AEG_FT_4905_Bed_Anl1.qxd 01.03.2005 12:17 Uhr Seite 25