Problem
Possible solution
Make sure that the drain hose has no kinks
or bends.
The anti-flood device is on.
Close the water tap and contact the Service.
After the checks are completed, activate
the appliance. The programme contin-
ues from the point of interruption.
If the problem occurs again, contact the
Service.
If the display shows other alarm codes,
contact the Service.
10.1
If the washing and drying
results are not satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is
too much. Adjust the rinse aid selector
to a lower position.
• The quantity of detergent is too much.
Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is
not sufficient. Adjust the rinse aid se-
lector to a higher position.
• The quality of the detergent can be
the cause.
Dishes are wet
• The programme is without a drying
phase or with a low temperature dry-
ing phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent
tablets can be the cause. Try a differ-
ent brand or activate the rinse aid dis-
penser and use rinse aid together with
the combi detergent tablets.
Refer to ‘HINTS AND TIPS’ for
other possible causes.
10.2
How to activate the rinse
aid dispenser
1.
Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode, refer to
“Setting and starting a programme”.
2.
Press and hold, at the same time,
De-
lay
and
Start
until the indicators of
,
and
start to flash.
3.
Press
Option
.
• The indicators of
and
go off.
• The indicator
continues to
flash.
• The display shows the current set-
ting.
Rinse aid dis-
penser off
Rinse aid dis-
penser on
4.
Press
Option
to change the setting.
5.
Press the on/off button to deactivate
the appliance and to confirm the set-
ting.
6.
Adjust the released quantity of rinse
aid.
7.
Fill the rinse aid dispenser.
11.
TECHNICAL INFORMATION
Dimensions
Width / Height / Depth
(mm)
596 / 850 / 610
Electrical connection
Refer to the rating plate.
Voltage
220-240 V
30 www.aeg.com
