44
Connecting the dishwasher
Connecting to the water supply
•
The dishwasher can be connected to cold and hot water supplies up
to max. 60°C.
•
The dishwasher must not be connected to open hot water appliances
or instantaneous water heaters.
Permitted water pressure
Connecting the inlet hose
1
The water inlet hose must not be kinked, crushed or entangled when it
is being connected.
Connect the threaded hose fitting (ISO 228-1:2000) on the water inlet
hose to a tap with an external thread (¾ inch). The inlet hose is fitted
with either a plastic or a metal nut:
–
Only
tighten the nut
hand tight
.
Then do a visual check for water tightness. (Make sure that the tap is
not dripping.)
3
So that access to the tap in the kitchen is not restricted by the use of
the dishwasher, we recommend installing an additional tap, or fitting a
T-branch to the existing tap.
If you need a longer water inlet hose than that supplied, the following
VDE-approved complete hose sets are to be used. These are available
from your local dealer.
–
Hose kit “WRflex 100” (Code: 911 239 034)
–
Hose kit “WRflex 200” (Code: 911 239 035)
Lowest permitted water pressure:
0,1 MPa ( = 1 bar = 10 N/cm
2
)
Consult your plumber if the water pres-
sure is less than 0,1 MPa.
Highest permitted water pressure:
1 MPa ( = 10 bar = 100 N/cm
2
)
If the water pressure is greater than
1 MPa, a pressure reduction valve must be
used (available from your dealer).