AEG CCB54483BW, User Manual

Page: 28 / 36

The back lamp
1. Turn the lamp glass cover to remove
it.
2. Clean the glass cover.
3. Replace the lamp with a suitable
300 °C heat-resistant lamp.
4. Install the glass cover.
14. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
14.1 What to do if...
Problem Possible cause Remedy
You cannot activate the ap‐
pliance.
The appliance is not connec‐
ted to an electrical supply or
it is connected incorrectly.
Check if the appliance is cor‐
rectly connected to the elec‐
trical supply.
The fuse is blown. Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali‐
fied electrician.
You cannot activate or oper‐
ate the hob.
The fuse is blown. Activate the hob again and
set the heat setting in less
than 10 seconds.
Residual heat indicator does
not come on.
The zone is not hot because
it operated only for a short
time.
If the zone operated suffi‐
ciently long to be hot, speak
to an Authorised Service
Centre.
You cannot activate the out‐
er ring.
Activate the inner ring first.
The oven does not heat up. The oven is deactivated. Activate the oven.
The necessary settings are
not set.
Make sure that the settings
are correct.
The clock is not set. Set the clock.
The lamp does not operate. The lamp is defective. Replace the lamp.
Steam and condensation
settle on the food and in the
cavity of the oven.
You left the dish in the oven
for too long.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
It takes too long to cook the
dishes or they cook too
quickly.
The temperature is too low
or too high.
Adjust the temperature if
necessary. Follow the advice
in the user manual.
The display shows "12.00". There was a power cut. Reset the clock.
www.aeg.com 28