4.
Hold the door with one hand on each
side and pull it away from the oven at
an upwards angle.
5.
Put the door with the outer side
down on a soft cloth on a stable
surface.
6.
Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
1
2
B
CAUTION!
Rough handling of the glass,
especially around the edges
of the front panel, can cause
the glass to break.
7.
Pull the door trim to the front to
remove it.
8.
Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
9.
Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, do the
above steps in the opposite sequence.
Install the smaller panel first, then the
larger and the door.
WARNING!
Make sure that the glasses
are inserted in the correct
position otherwise the
surface of the door may
overheat.
Make sure that you put the glass panels
(C, B and A) back in the correct
sequence. First, insert panel C, which has
a square printed on the left side and a
triangle on the right side. You will also
find those symbols embossed on the
door frame. The triangle symbol on the
glass must match the triangle on the
door frame, and the square symbol must
match the square. After that insert the
other two glass panels.
A B C
11.7
Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1.
Turn off the oven.
Wait until the oven is cooled down.
2.
Disconnect the oven from the mains.
3.
Put a cloth on the bottom of the
cavity.
The top lamp
1.
Turn the lamp glass cover to remove
it.
2.
Clean the glass cover.
3.
Replace the lamp with a suitable 300
°C heat-resistant lamp.
4.
Install the glass cover.
www.aeg.com
38
