AEG BP5014301M, User Manual

Page: 36 / 44

Problem Possible cause Remedy
The core temperature sensor
does not operate. The plug of the core tem-
perature sensor is not cor-
rectly installed into the sock-
et. Put the plug of the core tem-
perature sensor as far as
possible into the socket.
There is water inside the
oven. There is too much water in
the tank. Deactivate the oven and
wipe the water with a cloth
or sponge.
The steam cooking does not
work. Lime obstructs the hole. Check the steam inlet open-
ing. Remove the lime.
The steam cooking does not
work. There is no water in the tank. Fill the water tank.
It takes more than three mi-
nutes to empty the water
tank or the water leaks from
the steam inlet opening. There are lime deposits in
the oven. Clean the water tank. Refer
to "Cleaning the water
tank".
It takes too long to cook the
dishes or they cook too
quickly. The temperature is too low
or too high. Adjust the temperature if
necessary. Follow the advice
in the user manual.
Steam and condensation
settle on the food and in the
cavity of the oven. You left the dish in the oven
for too long. Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
The display shows "C2". You want to start the Pyroly-
sis or Defrost function, but
you did not remove the core
temperature sensor plug
from the socket. Remove the core tempera-
ture sensor plug from the
socket.
The display shows "C3". The cleaning function does
not operate. You did not
fully close the door, or the
door lock is defective. Fully close the door.
The display shows "F102". • You did not fully close
the door.
• The door lock is defec-
tive.
• Fully close the door.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows
"F102" again, contact the
Customer Care Depart-
ment.
www.aeg.com 36