AEG BE3002001, User Manual

Page: 25 / 32

2. Hold the door t (B) on the top edge of
the door at the two sides and push in -
wards to release the clip seal.
3. Pull the door t to the front to remove it.
4. Hold the door glass panels on their top
edge one by one and pull them up out of
the guide
5. Clean the door glass panels.
To install panels follow the procedure in re
-
verse. Install the smaller panel first, then the
larger.
WHAT TO DO IF…
WARNING!
Refer to "Safety information" chapter.
Problem Possible cause Remedy
The oven does not heat up The oven is not switched on Switch on the oven
The oven does not heat up The clock is not set Set the clock
The oven does not heat up The necessary settings are not
set
Control the settings
The oven does not heat up The fuse in the fuse box is re -
leased
Control the fuse. If the fuse is
released more than one time,
refer to a qualified electrician.
The oven lamp does not operate The oven lamp is defective Replace the oven lamp
F11 appears in the clock display The core temperature sensor
has short circuit or the plug of
the core temperature sensor is
not tightly in position in the
socket
Insert the plug of the core tem -
perature sensor as far as it will
go into the socket on the side
wall of the oven
If you cannot find a solution to the problem yourself, contact your dealer or the service
centre.
The necessary data for the service centre is on the rating plate. The rating plate is on the
front frame of the oven cavity.
We recommend that you write the data here:
B
What to do if… 25