AEG AEGFFS2, Installation And Operation Manual

Page: 19 / 23

TABLE OF CONTENTS
BEFORE YOU START 37
SPECIFICATIONS AND DIMENSIONS 37
PARTS & TOOLS 37
TYPICAL UNDERSINK INSTALLATION 37
INSTALLATION INSTRUCTIONS 39
Step A - Install Water Supply Fittings 39
Step B - Make Tubing Connections 39
Step C - Install the Filter Cartridge 40
Step D - Turn On Water, Check for Leaks and Rinse Carbon Fines 40
FILTER CARTRIDGES 41
FILTER CARTRIDGE LIFE 41
FILTER CARTRIDGE REPLACEMENT 41
TROUBLESHOOTING THE SYSTEM 42
EXPLODED VIEW & PARTS LIST 42
BEFORE YOU START
• Read all steps and guides carefully before installing and using your undersink full flow water filtration
system. Follow all steps exactly to correctly install. Reading this manual will also help you to get all the
benefits from the filtration system.
• Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection
before or after the system. This system is certified for cyst reduction and may be used on disinfected
waters that may contain filterable cysts.
• All plumbing should be done in accordance with local codes and requirements.
• The undersink full flow water filtration system works on water pressures between 2.1 bar and 6.9 bar
(between 30 psi and 100 psi). If your house water pressure is over the maximum, install a pressure
reducing valve in the water supply pipe to the filtration system.
• Do not install the filtration system outside, or in extreme hot or cold temperatures. Temperature of the
water supply to the filtration system must be between 4°C and 38°C (between 40°F and 100°F). Do
not install on hot water.
SPECIFICATIONS & DIMENSIONS
Supply Water Pressure Min. - Max 2,1 - 6,9 bar
Supply Water Temperature Min. - Max. 4 - 38°C
Rated Service Flow 7.6 liters per minute
Inlet - Outlet 9.5 mm (3/8») quick connect fittings and tubing included
14-1/2"
4" 3"
1"
2,5 cm
36,6 cm
10,2 cm 7,6 cm FIG.1
36 37