AEG 948904337, User Manual

Page: 29 / 36

1. Push the door trim at one side to
remove it.
1
2
A
2. Pull up the trim.
3. Remove the glass panels.
To replace the glass panels,
do the same steps in
reverse. Before you lower
the trim, attach the A trim
part to the door. Refer to the
image.
12.9 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the oven. Wait until the oven
is cold.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the
cavity.
The back lamp
The lamp glass cover is at
the back of the cavity.
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Clean the glass cover.
3. Replace the oven lamp with a
suitable 300 °C heat-resistant oven
lamp.
Use the same oven lamp type.
4. Install the glass cover.
13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1 What to do if...
Problem Possible cause Remedy
You cannot activate the ap‐
pliance.
The appliance is not connec‐
ted to an electrical supply or
it is connected incorrectly.
Check if the appliance is cor‐
rectly connected to the elec‐
trical supply.
You cannot activate the ap‐
pliance.
The fuse is blown. Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali‐
fied electrician.
Residual heat indicator does
not come on.
The zone is not hot because
it operated only for a short
time.
If the zone operated suffi‐
ciently long to be hot, speak
to an Authorised Service
Centre.
ENGLISH 29