AEG 30Z, Instruction Manual

Page: 41 / 121

Button sewing
Change the presser foot with the button
sewing foot.
Install the darning plate.
Position the work under the foot.
Align two holes of the button with the slot of
the presser foot and lower the foot to hold
the button securely.
Adjust the stitch width according to the
distance between the two holes of the
button.
Turn the handwheel to check that the needle
goes cleanly into the left and right hole of the
button.
Make sure that the needle does not hit the
button during sewing, otherwise the needle
may break.
Sew approximately 10 stitches at slow speed.
Raise the foot and cut the remaining threads
about 10 cm from the fabric.
Pull the end of the upper thread to the back
of the fabric, then tie it with the bobbin
thread.
If a shank is required (ex. sew on coats or
jackets), place a darning needle on top of the
button and sew.
For buttons with 4 holes, sew through the
front two holes first, push the work forward
and then sew through the back two holes.
Remove the darning plate.
Stitch Width
39
Instruction manual for Model AEG 30Z /AEG 35Z