AEG 17166GT-MN, User Manual

Page: 10 / 32

In the absence of electricity
you can ignite the burner
without an electrical device.
In this case approach the
burner with a flame, push
the relevant knob down and
turn it to maximum position.
Keep the knob pushed for
equal or less than 10
seconds to let the
thermocouple warm up.
If the burner accidentally
goes out, turn the knob to
the off position and try to
light the burner again after
minimum 1 minute.
The spark generator can
start automatically when you
switch on the mains, after
installation or a power cut. It
is normal.
5.2 Burner overview
A
B
C
D
E
F
G
H
I
A
B
D
G
E
C
F
H
I
A.
Burner cap
B.
Burner crown
C. Ignition candle
D. Thermocouple
E. Hob
F. Slots
G. Burner body
H. Location peg
I. Hole for the ignition candle
5.3 Replacing burner parts
1. Put carefully the burner crown on the
burner body. Let the crown fall freely
onto the body. Do not use force.
Make sure that the hole in the crown
is above the ignition candle.
Make sure that the location pegs are
in the slots in the burner body.
Make sure that you can move the
crown a small distance from side to
side.
2.
Put the burner cap centrally on top of
the crown.
Make sure that the cap is correctly
installed, with the enamel side up
and you can move the cap from side
to side and front to back.
3. Light the burner.
If the burner does not ignite, adjust the
crown and cap again.
5.4 Turning the burner off
To put the flame out, turn the knob to
the off position .
www.aeg.com 10