Information subject to change
96-8005549_3-18-21
8508 OPERATOR’S MANUAL – SECTION 2
6
2
Amplifier Unpacking and
Installation
8500 series amplifiers are precision instruments
that can be dangerous if not handled properly. Le-
thal voltages are present in both the AC input sup-
ply and the output of the amplifier. For this reason,
safety should be your primary concern when you
setup and operate this amplifier.
2.1 Safety First
Throughout this manual special emphasis is
placed on good safety practices. The following
graphics are used to highlight certain topics that
require extra precaution.
To uncrate the product, remove the top and one
side of the crate, then use a lift or other suitable
equipment to glide the amplifier from the crate and
off the pallet. Cable lift rings are installed at the
amplifier top corners to facilitate product removal
(see
Figure 2.1
).
DANGER represents the most severe
hazard alert. Extreme bodily harm or
death will occur if these guidelines are
not followed. Note the explanation of the
hazard and instruction for avoiding it.
DANGER
WARNING alerts you to hazards that
could result in severe injury or death.
Note the explanation of the hazard and
the instructions for avoiding it.
WARNING
CAUTION indicates hazards that could
result in potential injury or equipment
or property damage. Once again, note
the explanation of the hazard and the
instructions for avoiding it.
CAUTION
2.2
Unpacking
Your amplifier will be delivered to the ship-to ad-
dress enclosed in a wooden crate and transported
on a special, shock-absorbing pallet. With the
addition of packaging, the amplifier can weigh up
to 700 pounds (318 kg). To avoid serious injury
and/or product damage, use a heavy-duty lift or
other suitable equipment to unpack and move the
product to its place of installation.
The amplifier has been tested and inspected for
damage before leaving the factory. Carefully un-
pack and inspect the product for damage.
Please
note any damage for future reference and
notify the shipping company immediately if
damage is found.
Also, please save the shipping
crate and pallet as evidence of damage and/or for
returning the amplifier for repair.
2.3
Check Contents
In addition to the 8500 series amplifier, your ship-
ment should include the following:
1.
Quick Start Guide
2.
8500 series Operation Manual on USB drive
2.4 8500 Series Placement
8500 series amplifiers are mounted on wheels to
allow rolling on a flat, smooth surface. To avoid
possible tipping, always push the amplifier from
the front and avoid rough or pitted surfaces.
Locate your amplifier near a three-phase power
source. Allow enough clearance at the front and
back of the amplifier to allow adequate airflow and
hot air discharge through the amplifier rear. See
Figure 2.2
for clearance recommendations
Never attempt to lift the cabinet without
assistance. Crushing bodily injury can
result if care is not taken during instal
-
lation. Cabinets may overturn if not
secured.
WARNING
Figure 2.1 – Cable Lift Rings
Summary of Contents for 8500 Series
Page 2: ......
