AE TECHRON MULTI-AMP CONFIGURATION GUIDE
97-8002465_09-19-14
Information subject to change
31
Figure E-4 – 2110/2120/7548/7796 Output
Terminal Resistor
Appendix E: Returning Slave Amplifiers to Stand-Alone Use
The configuration settings required for Series system operation must be returned to the factory-default
settings before a Slave amplifier can be used as a stand-alone amplifier. To reconfigure your Slave amplifiers
for stand-alone use, complete the following.
Amplifier Main Board Settings
IMPORTANT: Before accessing the Main Board, make sure
the amplifier is turned off for at least 3-5 minutes and the
AC mains are disconnected.
Accessing the 2105/7224 Amplifier Main Board
2105 and 7224 amplifiers contain an Access Panel built into
the top cover to allow easy access to the amplifier main board
for configuration of the Master/Slave setting.
On each 2105/7224 amplifier that has been configured for
1.
Slave operation, locate the Access Panel as shown in Figure
E-1. Make sure that all 8 screws are accessible. Remove
the unit from its rack, if necessary.
Using a #2 Phillips screwdriver, remove the 8 screws
2.
located on the top and side of the amplifier.
Remove the Access Panel and set it aside.
3.
Accessing the Main Board on 2110/2120/7548/7796
Amplifiers
The 2110, 2110, 7548 or 7796 amplifier Main Board can be
accessed by removing the amplifier front panel.
Turn the power to the amplifier “OFF”.
1.
Remove the four hex-head screws, located along the left
2.
and right edges of the amplifier front panel.
Remove the front cover by pulling straight towards you.
3.
Set Master/Slave Jumpers
On the main board, locate the jumpers P1 and P2
(Master/Slave). For Master operation, set both jumpers to the
UP position (upper two pins shorted). See
FigureE-2
for jumper
locations.
Re-install Output Terminal Resistor
For each Slave amplifier that has been configured for Series
– Single Ended Output configurations, it is important to re-
install the output terminal resistor.
On each Slave amplifier back panel, re-install the resistor
connecting the terminals labeled COM (2105 and 7224
amplifiers) or SAMPLED COMMON (2110, 2120, 7548 and
7796 amplifiers) and CHASSIS GROUND on the output
connector. See
Figures E-3 and E-4.
Figure E-3 – 22105/7224 Output Terminal Resistor
Figure E-1 – 2105/7224 Access Panel Screw Locations
Figure E-2 – Master/Slave Jumper Locations
