advidia VP-16 Series, User Manual

Page: 19 / 32

18
Instructions:

The VP-16 video server can be accessed either by client software or by IE browser.

Before access, user needs to configure the network settings of VP-16 according to Chapter 3.

Connect the VP-16 to the LAN, and prepare a PC connected to the same LAN with VP-16.

The factory default username of VP-16 is “admin
”
and the password is “12345.”

The factory default IP address of VP-16 is 192.0.0.64 and the port is 8000.
4.1 Install the Client Software
4.1.1 System Requirements
Open the accessories box to take out the disk, which provides camera finder software supplied by our corporation.
The following section describes the configuration of encoder through the software.
Operating System: Microsoft Windows 2000 or higher
CPU: Intel Pentium IV 2.4 GHz or higher
RAM: 1G or higher
Display: 1024×768 resolution or higher
4.1.2 Install Software
Double click icon and you will see the wizard shown as below:
Figure 4.1.2.1
Click “Next” to continue, and input the user information, software installed location according to the hints.
An SADP installation wizard will pop up; click “Next” to start to install WinPcap. If it is already installed, the
installation can be cancelled.