37
A.9 CompactFlash Master/Slave & Hard Drive Settings
UNO-1150 has one internal Compact Flash card slot which supports
Compact Flash type I (3mm thick) and type II (5 mm thick) cards.
The CompactFlash interface uses a primary IDE channel, which can be
set as the master or slave device by changing the setting of SW7.
For UNO-1150E:
1.
The CompactFlash interface uses a primary IDE channel. In UNO-
1150E please set the Compact Flash as Master device by switch
SW7-1 as on.
2.
The SATA enable switch need to be switched on when using a
SATA hard drive and required to switch off when there’s no SATA
hard drive.
Note:
Please check your storage device configuration settings
carefully while using storage device.
Table A.11: CompactFlash Master/Sl
Pin Setting
Description
1
ON (Default)
CF is Master Device
OFF
CF is Slave Device
2
Reserve
Table A.12: SATA Enable Settings
Pin Setting
Description
1
ON (Default)
CF is Master Device
OFF
CF is Slave Device
2
ON
Use SATA hard drive
OFF (Default)
No SATA hard drive was used
Note:
1. If you develop WinCE OS on a CompactFlash card
yourself, we strongly recommend setting it to Master.
2. Only one hard drive is allowed.
3. Using CompactFlash and HDD together is not recom-
mended. If it is necessary, please set CompactFlash as
Master (1: On) and set SATA Enable (2-On)
