Advantech SOM-C350, User Manual

Page: 50 / 108

SOM-C350 User Manual 38
0 if num of 1's in the data bits is odd. Mark: parity bit is always 1. Space: Par -
ity bit is always 0. Mark and Space Parity do not allow for error detection.
They can be used as an additional data bit.
– Stop Bits
Stop bits indicate the end of a serial data packet. (A start bit indicates the
beginning). The standard setting is 1 stop bit. Communication with slow
devices may require more than 1 stop bit.
– Flow Control
Flow control can prevent data loss from buffer overflow. When sending data,
if the receiving buffers are full, a 'stop' signal can be sent to stop the data
flow. Once the buffers are empty, a 'start' signal can be sent to re-start the
flow. Hardware flow control uses two wires to send start/stop signals.
– VT-UTF8 Combo Key Support
Enable VT-UTF8 Combination Key Support for ANSI/VT100 terminals
– Recorder Mode
With this mode enabled only text will be sent. This is to capture Terminal
data.
– Resolution 100x31
Enables or disables extended terminal resolution
– Putty KeyPad
Select FunctionKey and KeyPad on Putty.

Legacy Console Redirection Settings
Figure 3.24 Legacy Console Redirection Settings
– Redirection COM Port
Select a COM port to display redirection of Legacy OS and Legacy OPROM
Messages