Advantech SmartFlex Series, Start Manual

Page: 14 / 20

SmartFlex
3. Power
The router requires an external DC power supply. The DC voltage required is between
+10 to +60 V DC. The router has built-in protection against reverse polarity without signaling.
Connect the power supply cable to the
PWR connector on the front panel of the router (see
the figure below).
4. Ethernet
An Ethernet cable may be connected to the
ETH0
connector on the front panel (see the
figure above). By default, this Ethernet port is configured as follows:
Connector Purpose Default Setting
ETH0 LAN port (default)
Connect your laptop or PC to this port to
get a local web-server for device configu-
ration and diagnostics.
DHCP Server
IP Address: 192.168.1.1
NetMask: 255.255.255.0
Configuration
1. Configuring the Device Using the Web Browser
You can access the router for status monitoring, configuration, and administration after
entering the IP address of the router into the web interface. The default router IP address is
192.168.1.1 (netmask 255.255.255.0). Configuration access is allowed for the user "root". The
default password is printed on the router’s label.
2
Attention, it is necessary to use HTTPS
protocol for secure communication over a network! For a detailed description and exam-
ples of the router configurations, see the Configuration manual.
2
If the router’s label does not contain a unique password, use the password "root".
QSG-0002-EN, January 24, 2020 13 Released in the Czech Republic