____________________________________________________________________________________________________
SKY-8201L Manual V02 20180420
Copyright 2016 Advantech Co. Ltd. All rights reserved.
Page 82
To re-install the top cover slide it onto the unit from the top with the top cover flange
facing the unit
’s face plate. Keep a gap of about an inch between the front plate and
the flange. After that, slide the top cover forward until the flange is fully seated
underneath the face plate. Now tighten the thumb screws.
3.3.3 PCIe Card Installation
Note!
You need:
- A PH2 screw driver
- PCIe cards are to be installed
After removing the top cover, follow the instructions below:
1.
If any PCIe cards are already installed before, please remove all IO cables and / or
extra power cables.
2.
Loosen the seven cage securing screws that secure the PCIe card cage. Make
sure they are fully unscrewed.
3.
Grab the card cage and and pull the card cage evenly and straight to the top. You
should feel a small
“bump” when the riser card disengages with the motherboard.
Keep pulling the card cage to the top until it is fully removed from the chassis and
put it on the desk with the riser card connector facing towards you.
4.
Remove the blank plate(s) on the slot(s) you want to install a card / cards in using
a PH2 screw driver.
5.
Remove the card holder at the rear side of the card cage. Make sure to retain the
screws.
6.
Insert the card(s) to be installed. Make sure the card(s) align with the IO opening
as well as the PCIe connector during installation. When installed, secure the card
’s
face plate using the screw left over from removing the blank panel.
7.
If the PCIe cards need extra power supplies, connect the power cables to the PCIe
cards
8.
Re-install the card holder.
9.
Turn around the card cage assembly and re-insert it into the SKY-8201 system.
Make sure the card cage is fully seated before you fasten the securing screws that
hold the card cage in place.
10. Install the top cover.
11. Reconnect primary power and power on the unit.
12. Enter the BIOS setup menu, launch the EFI shell and use the PCIe device display
command to validate that the newly installed board(s) has/have been properly
recognized.
13. Leave the BIOS and boot the OS.
Summary of Contents for SKY-8201L Series
Page 2: ......
