2
2
2
2
2
PCM-3730 User's Manual
Installation
Initial inspection
We carefully inspected the PCM-3730 both mechanically
and electrically before shipment. It should be free of marks
and in perfect order on receipt.
As you unpack the PCM-3730, check it for signs of shipping
damage (damaged box, scratches, dents, etc.). If it is
damaged or fails to meet specifications, notify our service
department or your local sales representative immediately.
Also, call the carrier immediately and retain the shipping
carton and packing material for inspection by the carrier.
We will then make arrangements to repair or replace the
unit.
Discharge any static electricity on your body before you
touch the board by touching the back of the system unit
(grounded metal).
Remove the PCM-3730 module from its protective
packaging by grasping the rear metal panel. Handle the
card only by its edges to avoid static electric discharge
which could damage its integrated circuits. Keep the
antistatic package. Whenever you remove the card from the
PC, please store the card in this package for protection.
You should also avoid contact with materials that hold static
electricity such as plastic, vinyl and styrofoam.
Switch and jumper settings
The PCM-3730 module has one function switch and three
jumper settings. The following sections tell how to configure
the card. You may want to refer to the figure below for help
in identifying module components.
Connectors, Jumpers, and Switches
Connectors, Jumpers, and Switches
Connectors, Jumpers, and Switches
Connectors, Jumpers, and Switches
Connectors, Jumpers, and Switches
Label
Label
Label
Label
Label
Function
Function
Function
Function
Function
CN1
CN1
CN1
CN1
CN1
Digital output
CN2
CN2
CN2
CN2
CN2
Digital input
PCM-3730 REV.A1
CN1
CN2
SW1
JP2
JP4
JP3
CN3
PCLD-782B Isolated D/I Board
This board provides 24 optically-isolated digital input
channels and a cable to connect to the PCM-3730's digital
input ports.
PCLD-885
The PCLD-885 provides 16 SPST power relay channels
with a maximum contact rating of AC: 250 V, 5 A or DC: 20
V, 5 A. The PCLD-885 can be driven directly by the digital
outputs of PC-LabCards through 20-pin flat-cable
connectors or 50-pin OPTO-22 compatible connectors.
PCLD-780
This wiring terminal board makes analog or digital I/O
connections easy.
PCLD-880
The PCLD-880 is a universal screw terminal board for
industrial wiring. It can be used with the analog or digital
ports of various PC-LabCards via 20-pin flat cables or
shielded round cables with DB-37 connectors.
