PCA-6743 User Manual
36
PS/2 keyboard communicates with the keyboard controller. The speed of the
data link depends on the clock signal generated by the keyboard controller.
Onboard FDC Controller [Enabled]
This item allows user to enabled or disabled chipset FDD controller.
Onboard Serial Port 1 [03F8h]
Serial Port1 IRQ [IRQ4]
This item allows user to change COM 1 address and IRQ.
Onboard Serial Port 2 [02F8h]
Serial Port 2 IRQ [IRQ3]
This item allows user to change COM 2 address and IRQ.
Onboard Serial Port 3 [03E8 / IRQ10]
This item allows user to change COM 3 address and IRQ.
Onboard Serial Port 4 [02E8 / IRQ5]
This item allows user to change COM 4 address and IRQ.
UART Mode select [Normal]
This item allows you to select UART mode.
RxD, TxD Active [Hi, Lo]
This item allows you to determine the active of RxD, TxD.
IR Transmission Delay [Enabled]
This item allows you to enable or disable IR transmission delay.
UR2 Duplex Mode [Half]
This item allows you to select the IR half/full duplex function.
Use IR Pins [IR-Rx2Tx2]
This items allows you to choose IR pins.
Onboard Parallel Port [378 / IRQ7]
This field sets the address of the on-board parallel port connector. You can
select either [378/IRQ7], [278/IRQ5] or Disabled. If you install an I/O card with a
parallel port, make sure there is no conflict in the address assignments. The
CPU card can support up to two parallel ports, as long as there are no conflicts
for each port.
Parallel Port Mode [ECP+EPP]
This field allows you to set the operation mode of the parallel port. The setting
"SPP" allows normal speed operation, but in one direction only. "EPP" allows
bidirectional parallel port operation at maximum speed. "ECP" allows the parallel
port to operate in bi-directional mode and at a speed faster than the maximum
data transfer rate. "ECP + EPP" allows normal speed operation in a two-way
mode
EPP Mode Select [EPP1.7]
This field allows you to select EPP port type 1.7 or 1.9.
ECP Mode Use DMA [3]
This selection is available only if you select "ECP" or "ECP + EPP" in the Parallel
Port Mode field. In ECP Mode Use DMA, you can select DMA channel 1, DMA
channel 3. Leave this field on the default setting.
Summary of Contents for PCA-6743
