Advantech PCA-6179, User Manual

Page: 53 / 118

Chapter 3 Award BIOS Setup 3 9
Realtek Bootstrap selection menu
1.- Disable network boot
2.- Network boot using interrupt 18h
3.- Network boot using interrupt 19h
4.- Network boot using PnP/BEV (BBS)
5.- Network boot from RPL (Int18h/19h)
Press 1, 2, 3, 4, or 5:
--> The ability to enable the RTL8139(X) BootROM to boot from
network depends on underly BIOS support. You should select
1.- disable network boot
If you like to disable RTL8139(X) PXE/RPL bootROM. The
Rtl8139(X) will operate normally, but will not attempt to remote
boot.
2.- Network boot using interrupt 18h
If your BIOS does not support BBS, but it supports “network
boot” in the boot device re-ordering list of the BIOS setup. And
then, select “network boot” as the first boot device.
3.- Network boot using interrupt 19h
If your BIOS (older platforms) does not support BBS, nor “
network boot” in the re-ordering list. Using “ Int 19h” will force
the RTL8139(X) BootROM to be the first boot device over the
Hard Disk and Floppy all the time.
4.- Network boot using PnP/BEV (BBS)
If your BIOS supports BBS. And then, select the PXE ROM as the
first boot device.
5.- Network boot from RPL (Int18h/19h)
If you like to remote boot from RPL server.
3.4.1 Virus Warning
While the system is booting up, and after boot-up, any attempt to write
to the boot sector or partition table of the hard disk drive will halt the
system. In this case, a warning message will be displayed. You can run
the anti-virus program to locate the problem.
If Virus Warning is disabled, no warning message will appear if