MIC-3392 User Manual
10
1.4.2
Clear CMOS (JP1)
This jumper is used to erase CMOS data and reset the system BIOS information. Fol-
low the procedures below to clear the CMOS.
1.
Turn off the system.
2.
Close jumper JP1 (1-2) for about 3 seconds.
3.
Set jumper JP1 as Normal.
4.
Turn on the system. The BIOS is reset to its default setting.
1.4.3
Switch Settings
SW5-1 selects the LAN port that is used for Serial Over LAN (SoL) functionality. The
10/100 LAN3 port is routed to the rear I/O but is not currently implemented on stan-
dard Advantech Rear I/O modules.
SW5-2 selects the routing of SATA channel 0 to either the onboard HDD socket or
Rear IO module.
Table 1.9: JP1 Clear CMOS
Default
Normal
open
Clear CMOS
closed
Table 1.10: SW5-1 LAN for BMC
Default
LAN2
on
LAN3 (reserved)
off
Table 1.11: SW5-2 SATA HDD channel setting (single PMC)
Default
On board
on
RTM
off
Table 1.12: SW5-2 SATA HDD channel setting (dual PMC)
Default
RTM
on
Summary of Contents for MIC-3392
