Advantech MIC-3351, Startup Manual

Page: 29 / 83

Chapter 2 Connecting Peripherals 1 9
Warning: Plug the other end of the cable into the drive with pin
1 on the cable corresponding to pin 1 on the drive.
Improper connection will damage the drive.
Note: We don't recommend connection to the following
Seagate brand IDE HDD models: ST 31276A, ST
31720A, ST 32531A, ST 33240A or ST 34340A
2.2 Floppy Drive (CN6)
One floppy disk drive can be connected to the MIC-3351 through the
on-board connector. The 1-slot wide mounting bracket shipped with
the MIC-3351 can accommodate one floppy disk drive. Please refer to
Figure 2-1 for the assembling procedures.
2.3 CompactFlash Interface (CN5)
This socket accepts an IDE-compatible CompactFlash memory card. If
a CompactFlash card is inserted in the CompactFlash socket and an
IDE drive (i.e. on-board HDD, CD-ROM) is being used at the same
time, remember to set the CompactFlash card as master and the IDE
drive as slave. (refer to section 1.5.4)
2.4 VGA Display Connector (CN1)
The MIC-3351 provides an VGA controller for a high performance VGA
interface. The MIC-3351's CN1 is a DB-15 connector for VGA monitor
input. Pin assignments for the VGA display are detailed in Appendix
B.
2.5 Parallel Port Connector (CN8)
The parallel port is normally used to connect the CPU card to a printer
and it is only supported by the MIC-3351 (MIC-3351S doesn't support