FWA-3260 User Manual v02
_20160302.docx
Copyright 2014 Advantech Co. Ltd. All rights reserved. Page 91
3.5.1.1
2.5” HDD
You need:
-
a PH2 screw driver
a standard 2.5” SATA HDDTo remove the HDD, proceed in the reverse of the installation
procedure in section 3.3.3.1:
5)
Detach the HDD power and SATA cables
6)
Remove the four screws on the corners of the HDD carrier plate and remove the
HDD carrier plate from the system
7)
Remove the HDD mounting screws and extract the HDD from the carrier plate.
8)
Install a new HDD by following the instructions in section 3.3.3.1.
3.5.1.2
M.2 SSD
You need:
-
a PH1 screw driver
-
a standard m.2 SSD
To remove a m.2 SSD proceed in the reverse of the installation procedure in section 3.3.3.2:
1)
Remove the m.2 mounting screw. Please be sure to hold the screw as the spring
mechanism in the m.2 connector will flip the m.2 module upwards once the screw is
lose.
2)
Extract the m.2 module
Install a new SSD following the mounting instructions of the same section.
3.5.2
CMOS Battery
You need:
-
A BR2032 battery
Warning!
There is the danger of explosion if the battery is replaced incorrectly. Replace the battery
only with the same or equivalent type specified above.
Dispose of used batteries according to the manufacturer's instructions.
To replace the RTC’s battery located at B1, pull the spring clip securing the battery forward
with your finger tip. Please handle with care and do not bend the spring clip. Then extract
the battery vertically.