FWA-3260 User Manual v02
_20160302.docx
Copyright 2014 Advantech Co. Ltd. All rights reserved. Page 81
Figure 48: Slide Top Cover back
Figure 49: Top Cover Flange Disengagement
Now lift off and remove the top cover.
3.3.2
Reinstalling the top cover
You need:
-
a PH2 screw driver
To re-install the top cover slide it onto the unit from the top with the top cover flange facing
the unit’s face plate. Keep a gap of about an inch between the front plate and the flange.
After that, slide the top cover forward until the flange is fully seated underneath the face
plate.
Now insert the screws in the 7 locations shown above. Tighten each screw only lightly then
move on to the next screw. After all screws have been inserted, tighten them.
3.3.3
Disk Installation
3.3.3.1
2.5” HDD drive
You need:
-
a PH2 screw driver
-
a standard 2.5” SATA HDD
-
the HDD screw kit (included in the unit)
-
the HDD carrier plate (included in the unit)
-
the SATA cable (included in the unit)
Figure 50: Screws for HDD mounting
After removing the top cover, follow the instructions below for 2.5” disk installation:
1)
Remove the plastic bag that protects the HDD carrier plate.