3. Insert the expansion card (take NMC card for example) into the bracket as shown in the figure below, and lock it with the removed
screws.
4. Insert the processed network card module into the PCI-E slot, and then use the removed four screws to lock the bracket in the
position shown by the arrow in the figure below.
If you install two expansion cards, you need to confirm whether the pins of the lower expansion card touch the base. If so, you need
to do insulation treatment before installing.
Installing HDD
-
If the riser card position need to install the HDD, you need to remove the riser card first
1. Refer to the figure below to remove three screws at the arrow and pull out the card.
2. Remove the copper post from the accessory box and lock it on the base chassis.
3. Take out six anti-vibration washers and HDD brackets from the accessory box, and install them in the positions shown by the arrows
in the figure below.
