18
EKI-9502G Series User Manual
2.2.7.4
Wiring the Power Inputs
To wire the power inputs:
Make sure the power cable is not connected to the switch or the power converter
before proceeding.
1.
Remove the protection cap from the port.
Figure 2.19 Removing a Protection Cap
2.
Align the notch on the cable with the protrusion on the connector port. Before
inserting the cable, the cable must be aligned to the connector to prevent
damage to the pins in the port.
3.
Insert the cable and gently push it in. If there is any resistance, remove the
cable and re-align it with the connector.
4.
Once the cable is fully seated in the port, turn the nut on the cable to secure it to
the connector.
Figure 2.20 Installing the Power Cable
The power input is now connected to the switch. The switch can be powered on.
To remove the power inputs:
Caution!
Do not disconnect modules or cabling unless the power is first switched
off.
The device only supports the voltage outlined in the type plate. Do not
use any other power components except those specifically designated
for the device.
Warning!
Power down and disconnect the power cord before servicing or wiring
the device.
1
2
2
1