EKI-9502G Series User Manual
31
To access this page, click
1 WLAN
>
Advanced
.
Figure 3.9 1 WLAN > Advanced
The following table describes the items in the previous figure.
Client Settings
The Client Settings are available under the Wireless WAN Operation Mode. The
operation mode must be configured for Wireless WAN.
Item
Description
Client Settings
Beacon interval
Enter the value to define the time lag between each of the beacons
sent by the access point. Default: 100 ms (20 - 999).
Data beacon rate
(DTIM)
Enter the value to define the rate at which beacons are sent.
Default: 2 ms (1 - 255).
20/40 Coexistence
Click to disable or enable the coexistence, when enabled it
functions to avoid interference between wireless networks.
HT LDPC
Click to disable or enable the HT Low Density Parity Check
(LDPC) support, when enabled it supports receiving LDPC coded
packets.
Advanced WLAN Setting
RTS Threshold
Enter the value as the threshold for the request to send function. A
lower threshold increases the WLAN stability, default: 2347.
Transmission Power
Click the drop-down menu to set the transmission power.
Settings: Full, Half, Quarter.
WMM
Wireless Multimedia (WMM) is enabled by default.
Short Guard Interval
Click the drop-down menu to enable/disable the short guard
interval. In 802.11 operation, the guard interval is 800ns. The short
guard interval time is 400ns to allow for an increased throughput.
Submit
Click
Submit
to save the values and update the screen.