show interface configuration
I
show interface configuration status
switch(config)#
interface fastEthernet 2
switch(config-if)#
show interface configuration
show interface status
I
show interface actual status
switch(config)#
interface fastEthernet 2
switch(config-if)#
show interface status
show interface accounting
I
show interface statistic counter
switch(config)#
interface fastEthernet 2
switch(config-if)#
show interface accounting
no accounting
I
Clear interface accounting
information
switch(config)#
interface fastEthernet 2
switch(config-if)#
no accounting
3.1.5
Trunk Commands Set
Table 3.6: Trunk Commands Set
Commands
Level
Description
Example
aggregator priority
[1~65535]
G
Set port group system priority
switch(config)#
aggregator priority 22
aggregator activityport
[
Group ID
]
[Port Numbers]
G
Set activity port
switch(config)#
aggregator activityport 2
aggregator group
[GroupID] [Port-list]
lacp
workp
[Workport]
G
Assign a trunk group with LACP
active.
[GroupID] :1~3
[Port-list]:Member port list, This
parameter could be a port
range(ex.1-4) or a port list separate
by a comma(ex.2, 3, 6)
[Workport]: The amount of work
ports, this value could not be less
than zero or be large than the
amount of member ports.
switch(config)#
aggregator group 1 1-4 lacp workp
2
or
switch(config)#
aggregator group 2 1,4,3 lacp
workp 3
aggregator group
[GroupID] [Port-list]
nolacp
G
Assign a static trunk group.
[GroupID] :1~3
[Port-list]:Member port list, This
parameter could be a port
range(ex.1-4) or a port list separate
by a comma(ex.2, 3, 6)
switch(config)#
aggregator group 1 2-4 nolacp
or
switch(config)#
aggregator group 1 3,1,2 nolacp
show aggregator
P
Show the information of trunk group
switch#
show aggregator 1
or
switch#
show aggregator 2
or
switch#
show aggregator 3
no aggregator lacp
[GroupID]
G
Disable the LACP function of trunk
group
switch(config)#
no aggreator lacp 1
no aggregator group
[GroupID]
G
Remove a trunk group
switch(config)#
no aggreator group 2
3.1.6
VLAN Commands Set
Table 3.7: VLAN Commands Set
Commands
Level
Description
Example
vlan database
P
Enter VLAN configure mode
switch#
vlan database
Vlanmode
[portbase| 802.1q | gvrp]
V
To set switch VLAN mode.
switch(vlan)#
vlanmode portbase
or
switch(vlan)#
vlanmode 802.1q
or
switch(vlan)#
vlanmode gvrp
EKI-6558TI_EKI-6559TMI_Manual_ed2
30
