9
2.3
Preparing Installation
Before installing EKI-6311G for outdoor application or hard-to-reach location, we
recommend configuring and test all the devices first.
For configuring the EKI-6311G, please follow the quick steps below to power up
the EKI-6311G. Refer to Figure 2-4 for steps 1 through 5.
Figure 2-4
Step1 : Connect the DC plug of the AC/DC power adapter into the DC Input Port
of Inline Power Injector and the wall-mount plug into a power outlet or power strip
(refer to
page 6
). The Power LED on the Inline Power Injector will light up.
Step2 : Run the cross-over type uplink Ethernet cable from Data Input Port
(refer to
page 6
) to the Ethernet port on a PC.
Step3 : Connect the 30m CAT 5 Ethernet cable into the EKI-6311G unit. Hand
tighten the connector.
Step4 : Connect the remaining end of the 30m CAT 5 cable into the PoE labeled
AP/Bridge. This is the power side of the PoE that will power up the EKI-6311G.
When the EKI-6311G receives power over the Ethernet cable, the EKI-6311G will
start its boot up sequence and the Active LED on the Inline Power Injector will
light up.
You can configure the EKI-6311G via HTML browser, such as Microsoft Internet
Explorer or Netscape Navigator from a remote host or PC.