Rate Limiting
Here you can set up every port’s frame limitation type and bandwidth rate.
•
Ingress Limit Frame type:
Select the frame type you want to filter. The frame types have 4 options for
selecting:
All,
Broadcast/Multicast/Flooded Unicast,
Broadcast/Multicast,
and
Broadcast only
.
The four frame type options are for ingress frames limitation. The egress rate only supports ‘
All
’ type.
All ports support port ingress and egress rate control. For example, assume port 1 is 10Mbps; the user
can set the effective egress rate of port 1 as 1Mbps, ingress rate 500Kbps. The switch performs the
ingress rate by packet counter to meet the specified rate
•
Ingress:
Enter the port effective ingress rate (The default value is “0”)
•
Egress:
Enter the port effective egress rate (The default value is “0”)
•
And then, click
Apply
to make the settings take effect.
Figure 3.3-27
Rate Limiting
EKI-2748FI_Manual
76
Summary of Contents for EKI-2748FI
