ARMA-C125-CRM
21
5.
UNPACKING AND INSTALLATION
5.1
I
NSTALLATION
C
ONSIDERATIONS
1.
It is recommended that the amplifier should be installed in a rack.
2.
Regardless of the installation position, ensure that there is a clearance of at least 12 inches
(30 cm) between the air intake/exhaust (back of the unit) and any surface which may obstruct
the air-flow.
5.2
I
NSTALLATION
P
ROCEDURE
1.
Connect the waveguide output of the unit, using eight #10-32 x 1/2” screws and eight #10
lock washers, to the load.
2.
Connect the RF source to the RF input N-type connector J1, see
Figure 1:
Product Outline
at
page 11.
3.
Connect the AC power source to the AC connector (J5) at the back-panel of the unit.
4.
Proceed to
Section
6
at page 22 &
Section
7
at page 31, for OPERATION and
CONFIGURATION AND SET-UP instructions.
Note: The rotating speed of the cooling fan is temperature dependent.
