Advantech AIIS-5410P, User Manual

Page: 75 / 89

63 AIIS-5410P User Manual
Chapter 4
S
oftware
Installation
4.5 SATA RAID Setup
4.5.1 Introduction
To support demanding disk I/O, Intel® Q170 chipset integrates six Serial ATA control-
lers with software RAID 0, 1, 5, and 10 capabilities.
RAID 0 striping increases the storage performance and is designed to speed up data
transfer rates for disk-intensive applications.
RAID 1 mirroring protects valuable data that might be lost in the event of a hard drive
failure.
A RAID 5 array contains three or more hard drives where the data is divided into
manageable blocks called strips. Parity is a mathematical method for recreating data
that was lost from a single drive, which increases fault-tolerance. The data and parity
are striped across all the hard drives in the array. The parity is striped in a rotating
sequence to reduce bottlenecks associated with the parity calculations.
A RAID 10 array uses four hard drives to create a combination of RAID levels 0 and
1. The data is striped across a two-drive array forming the RAID 0 component. Both
drives in the RAID 0 array is then mirrored by a RAID 1 component.
4.5.2 SATA RAID Driver and Utility Setup
The installation utility is in the CD’s “06_Intel RAID_AHCI” folder. Go to the directory
of the CD and follow these steps to install.
4.6 Install USB3.0
4.6.1 Introduction
AIIS-5410P provides 8x USB 3.0 and the data transfer rate of USB3.0 (5Gb/s) is 10
times that of USB2.0 (480 Mbps).
Insert the driver CD into your system’s CD-ROM drive. Navigate to the "07 USB3.0"
to install the drier.
Note! Please install “.NET 4.5” before installing “Intel Rapid Storage Technol-
ogy”.