Customer Service 1-888-707-1880
or email [email protected] Dyaco Canada Inc. ©2014
9
STEP 3 ATTACH THE UPRIGHT
1.
There is a red strap and a black strap attached inside the upright (5). These straps are
to assist in pulling the sensor wire (34) and the tension cable (23) through the upright
(5).
2.
Pull the straps from their top ends to pull the sensor wire (34) through to extend out of
the top of the upright (5), and pull the tension cable (23) through and extend out from
the square hole at the side of the upright (5) as shown in the illustration below.
3.
Insert the upright (5) into the main frame (1) and tighten securely with button head
bolts (M8x1.25x15mm)(46), lock washers (M8)(52), arc washers (M8)(53), and
washers (M8)(54).
NOTE:
Don’t remove the straps from the sensor wire (34) and the tension cable (23) until
instructed to do so in later assembly steps.
5
23
34
Black Strap
Red Strap
1
46
52
53
5452
46
53
52
46
5
34
23
1
