17
Note:
If Rate and Volume tracking has been selected an alarm will occur if the defined MAX VOLUME
amount is measured within the defined TIME CYCLE which can be a 12-or-24 hour period.
RESET VOLUME
- Resets the Volume Alarm totalizer.
METER LINK
– This selection only shows if the tracking method is Rate and Volume and tells the auxiliary
flowmeter input to get its signals from one of the system water meters already wired to the controller’s water
meter inputs. If this is selected no wiring to the auxiliary input is required and the PULSE VALUE and UNITS
settings are auto populated from the particular water meter’s settings.
10. Relays
STATUS
- Allows for viewing accumulated relay ON
times, temporary forcing relays ON or OFF or seeing
which relay is on.
RESET
- Allows the accumulated run time of a
particular relay to be reset to zero.
FORCE
- Allows a relay to be manually forced ON
for a single event from 0-99 minutes. When the event
is over the relay goes back to its normal automatic
control
.
In the STATUS view the accumulated ON time is
shown along with the main activator, custom name and
current status:
ON = Relay on by relay activators
OFF = Relay off by normal logic
OFF-T = Relay off for daily max
OFF-D = Relay off for relay disabler
ON-A = Relay activated by activator other than main
action
H-ON = Relay manually forced on
H-OFF = Relay manually forced off
VI. WebAdvantage Setup
WebAdvantage Connection - SETUP CHECKLIST
• Do you have a WebAdv3 USER ID and password? _____
Yes
,
if ‘No’ proceed to page 18.
• Has your account admin added the device and linked it to your USER ID? _____
Yes
,
if ‘No’
proceed to page 19
.
Congratulations!
You are now ready to go online
with WebAdvantage. https://webadvantage.online/
>RELAYS<
STATUS
RESET
FORCE
>RELAY STATUS<
R01: ON
006:30:30
SYS1 COND BLEED
R02: OFF
008:56:35
SYS1 pH
R03: OFF-T
011:00:10
SYS1 TIMER1 INH
R04: OFF
007:00:00
SYS1 TIMER2 BIO1
R05: OFF
008:10:30
SYS1 TIMER3 BIO2
Complete
WebAdvantage
Manual